Sliding Gate - Horizontal Composite T&G Boards Made to Measure from Slats - SQM PRICE Guide

We cut to size your Sliding Gate - You assemble and Install

DIY

- SMS me your size to 0414237573

- Tell me what height and width

- Tell me either the white or Brown colour for the composite boards

- Tell me if you want black or white gate frames

- These are T&G so the gaps between boards is 0mm and interlocked

For example a typical 1600mm tall and 4500mm wide sliding gate and supplied in DIY form (which still needs assembly by you) and 0mm gaps would cost around $1351 which is around $193 per SQM. 

If you want us to assemble then supply and build is $250 extra.  We do not install at your location and the pickup is from Narangba.

This is to suit traditional horizontal configuration

If your BUY my manual roller kit the height of the wheels and track,  is 70mm off the concrete to the underside of the gate so allow for that when determining your gate height.

What you should know:

- Payment of $250 needs to be made for any custom orders of sliding gates

- We cut Tuesdays and Thursday each week so have orders in before that

- Protective sheets will be left on the material for you to remove.

- Allow + or - 10mm difference in final size

- If you buy DIY the tools you would need to build the gate would be a Tek drill, tape measure and a Square.

 

Gate outside Aluminum frame material is available in:

- Satin Black frame

- Gloss White frame

Wall Board Colours

- Brown

- White

- Dark grey limited supply

When cut allow a -10 to +10 tolerance for the size you ask. 

* Slider gates we add a 400mm motor tail to the gate to allow you to connect to your sliding gate motor.

* All Sliding gates are a tripple panel, to stop warping, so there will be 2 x aluminum breaker frames in the middle that join the boards.

* Longer than 5400mm it will come with 2 piece rails

We don't supply any motors but we can sell a manual roller kit for $300 with 7m track. (see other listings for the images). Extra metres are just $20 each

ANY HEIGHT CAN BE MADE - WE CUSTOM MAKE ALL OUR SLAT GATES AND PROVIDE EITHER FULL MADE OR DIY

Further Information on Installation

* You need to have DIY experience

* Price does not come with any posts

* Heavy Duty alloy 76mm x 76mm posts are available from our warehouse at $40lm or 100x100mm are $70lm

* If buying our 76x76mm posts for the closed Post, the one when the gate receiver goes on then it is $40LM

* Instructions are provided 

* Each install and each home is different.  You may need extra hardware or less hardware.

*At least 2 people needed to install

 

 

So you will have NO RUST for an aluminum frame and the surface stays is POWDER COATED to last a decade.  The wall boards are a high end co-extrusion and will give you 10 years of worry free use

  

Note

We supply sliding gates only.  We do not do measure and quotes or installs.

 

BULKY GOODS DELIVERY

- If only buying 1 x gate or 1 x panel then Australia wide wrapping and shipping is =$120.  

- If buying more, then see the flat rate shipping Info below:

-$140 flat rate fee to the Northside of Brisbane

-$200 flat rate fee to the Southside of Brisbane

-$250 flat rate fee to the Gold Coast, Ipswich or Sunshine Coast

-$350 flat rate fee to Sydney or Rockhampton

-$450 flat rate fee to Melbourne or Townsville

**We use backload trucks for most of the above and usually do all drops in other country towns we pass but following that main highway.  Sometimes these deliveries will be after hours

-All other areas we can quote to a home in your state or country town